PM Checklist

The checklist is an optional tool available for use to ensure adherence to the procedure and should not be used exclusively to drive full compliance with procedural directives.

Account:

 Location:

Contact title:

 Contact name:
Telephone:

Contact email:

BD MAX serial number:

 SW version:

Multi Meter Serial Number:

 Multi Meter Expiration Date:

Caliper serial number:

 Caliper expiration date:

Instrument Inspection

Confirm all parts/functions of instruments are functioning properly.

Description Y N NA
Did you verify all moving parts are working?      
Did you verify airline connections are tight?      
Did you perform Calrack?      
Did you verify Magnet Height, Depth and Tilt?      
Did you adjust Magnet Height?      
Did you adjust Magnet Depth and/or Tilt?      
Did you inspect the X, Y, and Z gantries and ensure they are functioning properly?      
Did you verify that the time and date on the All‐In‐ One is correct?      
Are ADF files updated to the latest version?      
Did you visually verify the belt condition?      
After verifying, did you have to set, replace, remove and/or loosen the belt?
      
If belt adjustments were required, did you use the belt frequency meter?
      
Did you check the Heater MUX boards’ cables for tension by moving the drawers in and out & up and down?      
Did you perform self‐test on Dewey and Louie?      
Did you perform load cartridge test?      
Did you perform CatalogWin Test?      
Did you check the condition of the Rack Flag sensors?      
Did you check and verify the Hinge door screw at the door?      
Did you verify that the power supply voltages are within the specification stated in the Preventive Maintenance Procedure?      
Did you perform qualification according to Qualification Run procedure?      
Did you check the normalizer ratios?      
If renormalization is required?      
If renormalization is required, did you perform renormalization successfully? If not required, please select N/A.
      
Did you upgrade the instrument to the latest SW Version? If No, please explain in Remarks below.      

Remarks:

 
Did you update all ServiceMax attributes as needed?      

Cleanings

Check instrument cleanliness.

Description Y N NA
Did you check and verify that the instrument and the area outside of the instrument is clean?      
Did you clean the air filter? If not required, select No.      

Comments

If N/A was selected as an option for any of the above questions, please justify why in the

space below.

N/A Justification

 

General comments

 

FSE & Customer Signature

  Print Signature Date

BD Field Service Engineer (FSE)

 

 

    

Customer